Fret Bevel File, 35 and 90 degrees. Diamond File.
- Product Code: TF014
- EAN: 5060489150172
- Availability: In Stock
£26.00 each & FREE Delivery in UK.** Order by 1pm for SAME DAY DISPATCH **
This is a diamond file mounted in a holder which allows it to be guided along the fretboard with the file cutting an accurate bevel on the fret ends.
The device is made in our workshops by Chris Alsop and provides an efficient and easy to use solution to getting the fret ends cleanly cut to a specific angle.
We have experimented with many designs for these and have come up with this solution.
• Very comfortable to hold file.
• For filing the ends of the frets level with the ends of the fretboard the file can be set at 90 degrees.
• For beveling the fret end at 35 degrees the file can be set accordingly. Easily accessible allen bolts clamp the file securely in either position.
• The file protrudes from the holder so you can see how the cut is progressing.
• Changeable Files. Long or short files of different grits can be installed.
• Smooth base made of low friction polymer, with bevelled at the ends. This base makes it easy to pass over the fret tops without bumping or damage.
• Robust construction from highest grade engineering polymer and professional quality diamond file.
• Dual Bevel Angle of 35 or 90 degrees
• File Length of 150mm
Fret Beveling in General
Advantages of using a Bevel File are that a really consistent professional job is achieved where all the fret ends are at the same angle. This main point about bevelling is to make sure there are no sharp edges or uncomfortable fret ends which hamper playing; if a fret end is too long then it disturbs the feel of the neck as the players moves around the fretboard, if the fret end angle is too shallow then the string can easily start to slip off the end of the fret. It is also suprising just how much of the fretboard space is used up by the bevels - a 45 degree bevel will use about 1mm of the fret wire and so reduce a 43mm neck to 41mm playable width. These bevel files can be made to any angle as low as zero and to a maximum of 60 degrees.
The bevel file is a fine grit diamond file which leaves a good finish - see the close up photo - and all that is needed is the final light sanding to remove any scratches or uncomfortable edges and finaly a polish - and the job's done.
FREE With This Item
• An advice sheet on using this toil
• A comprehensive guide to fret replacement
|Dispatch Time and Shipping Method|
|Dispatch Time||** Order by 1pm for SAME DAY DISPATCH **|
|UK||Royal Mail 1st Class Signed For|
|International||Royal Mail International Airmail Tracked|
|Shipping Costs For This Product|
|Single Item Shipping Cost
|Combined Shipping Cost
(at 75% Discount)
|Combined Shipping Cost||The cost is calculated as |
1) The item with the highest postal rate is charged at full rate
2) ALL additional items are charged at the discounted rate of 75%
TOTAL SHIPPING COST =
(Highest Postal Cost Item @ Full Rate) + (Additional items @ Discounted Rate);
|Length||File Length 150mm|
|File||Diamond File. Can be set at either 35 degree or 90 degree angle|